Quick take
- Lie = angle between the shaft and the ground at address.
- Toe up points the face left (RH). Toe down points it right.
- Matters most in short irons and wedges.
- Impact matters more than address; test with lie tape.
What lie angle is
Sole the club. The angle between the shaft and the ground is the lie angle. Iron lie angles typically run around 60–64°, more upright as clubs get shorter.
Why it changes direction
Lofted faces point where they're tilted. If the toe is up at impact, the face tilts left (for a right-hander). Toe down tilts it right.
- Too upright (toe up): shots start left.
- Too flat (toe down): shots start right.
The more loft, the bigger the effect. That's why wedges and short irons are the most sensitive.
Rough illustrative numbers at full distance. A few yards is the difference between a birdie putt and a fringe chip.
What changes lie at impact
- Your height and arm length.
- Posture and hand height at impact.
- Shaft droop during the swing (the toe dips slightly).
Hand height at impact is often higher than at address. So fitters check impact, not just how the club looks at setup.
How to check it
- Put lie tape (or a dry-erase line) on the sole.
- Hit off a lie board or a firm mat.
- Mark in the center? Good. Toward the toe? Too flat. Toward the heel? Too upright.
Adjusting it
Many forged irons and many cast irons can be bent about 1–2° by a club builder. Some hollow or multi-material heads have limits. Ask before bending.
Lie angle and the driver
The driver has very little loft, so lie angle affects its start line much less. It still matters for strike location and how the sole sits. Some adjustable drivers offer an upright setting that can help a slice slightly.
Wedges deserve attention
Because wedges have the most loft, a lie error causes the biggest direction miss. If your irons were bent, check your wedges too. Many golfers forget them, and that's where accuracy matters most.